TAPER MILL
MILLING THROUGH ANY RESTRICTION
DRILLSTAR Taper mill is used to repair collapsed casings or tubings, and to shave off cement or corroded parts in casings.
The taper mill hardfacing is designed to clean the casing without cutting it, and to penetrate very gradually. The upper part of the taper mill is long enough to allow the addition of stabilizing blades while still remaining easy to fish.
DRILLSTAR Taper mill is available in two types, long or short. Blades, whether spiralled or straight, are fully customizable.

STANDARD DIMENSIONS
Dressed OD> | API REG Pin | Length Long type | Length Short type | Neck Length | Neck OD | (lbs) Long type | (lbs) Short type |
3 1/4 - 3 7/8” | |||||||
4 - 4 3/8” | |||||||
4 1/2 - 5 3/8" | |||||||
5 1/2 - 5 5/8" | |||||||
5 3/4 - 6 3/8" | |||||||
6 1/2 - 7 3/8" | |||||||
7 1/2 - 7 7/8" | |||||||
8 3/8 - 9 1/2" | |||||||
9 3/8 - 9 7/8" | |||||||
10 3/8 - 11" | |||||||
11 1/2 - 12 1/4" | |||||||
14 3/4 - 15" | |||||||
17 - 17 1/2" | |||||||
20 - 26" |